Sea & Sea YS-50 Manuel d'instructions télécharger pdf (Page 31)

E-30

Troubleshooting

About LED indication

The power will turn off automatically

The auto power-off mode is turned on. When turning on the power again, set

the mode switch to ［OFF］ before setting it to the desired mode. (P.E-12)

Is the fiber-optic cable connected properly? (P.E-21)

Is the light level control dial in DS-TTL Ⅱ mode set at +/- compensation?

(P.E-13)

Please refer to our website

(http://www.seaandsea.jp) [Compatibility list for the

strobe and digital cameras]. (P.E-25)

There may not be any effect obtained from compensation with the light level

control dial depending on the shooting conditions and camera settings.

Illuminates

blue

Point to be checkedIndication Coping process Page

P.E-13

P.E-29

Slave-TTL mode has

been turned on

You can switch to TTL mode by

pressing and holding down the

target light switch for 3 seconds.

Illuminates

green for

about 2

seconds

P.E-13

TTL automatic light control

has been completed

Illuminates

red

P.E-13

Fully charged

The red

and green

lamps flash

alternately

There is no remaining

battery power.

Replace the battery with a

new one.

Ready to fire

blinks red

The protective circuit is

activated.

Turn off the power supply,

and put a product in a cool

place for a while.

The red

and blue

lamps flash

alternately

The sync cord sensor

operates.

If an error occurs while there

is no synchronized cord

connected, please contact the

World Customer Service Center

or an authorized SEA&SEA

dealer.

When photographs are taken in DS-TTL Ⅱ mode, the

captured images are too bright or too dark

1 2 ... 26 27 28 29 30 31 32 33

Commentaires sur ces manuels

Pas de commentaire

Sea & Sea YS-50 Manuel d'instructions Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Flashs d'appareils photo Sea & Sea YS-50