Sea & Sea YS-50 Manuel d'instructions télécharger pdf (Page 25)

E-24

Taking Photographs

Light amount of the strobe can be adjusted with the light level control dial.

When you shoot with a digital camera, set the built-in flash of the camera to

the forcaed-flash mode. The strobe will not fire unless the built-in flash of

the camera fires.

Manual photography

Using the Fiber-optic Cable

Set the mode switch to [ ] or [ ]

Set the camera’s built-in flash to the forced-flash mode, and

mount the camera to the housing. Then connect the housing

and this product together with a fiber-optic cable.

Adjust with the light level control dial

Take a photograph

When shooting with a digital camera that pre-flashes, set to [ ].

When shooting with a digital camera that does not pre-flash, set to [ ].

Relese the red-eye-reduction function.

Set the mode switch to [ ] and the

light level control dial to [FULL],

point the digital camera at the front of

the strobe and shoot an image.

The built-in flash of the camera must flash.

Check the image captured by the camera

If you see a white flash in the strobe or an

image that is completely white, then the

strobe has fired and the setting is correct.

If the image shows a dark reflection from the

strobe, that means that it is not synchronized

and the strobe didn’t fire. Change the mode

switch to [ ], try taking another picture,

and then check the new picture.

You can check whether the settings of the mode switch are correct, by shooting

the strobe with a digital camera. The number of times a digital camera’s

built-in flash will fire differs depending on the shooting mode. If you change

the shooting mode of the camera, check the setting of the mode switch again

for that mode.

To check the mode switch

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32 33

Pas de commentaire

Sea & Sea YS-50 Manuel d'instructions Page 25