Sea & Sea YS-50 Manuel d'instructions télécharger pdf (Page 24)

E-23

Taking Photographs

Light amount of the strobe can be adjusted with the light level control dial.

Manual photography

Using the Sync Cord

Set the mode switch to [ ] or [ ]

Adjust with the light level control dial

Take a photograph

Shooting with TTL flash output.

Photography based on the camera’s photometric data of the subject’s

brightness, which is used to regulate the light amount of the strobe so that

the correct exposure is achived. Even if the distance from the subject has

changed, the light amount will be controlled automatically and you can

easily obtain the correct exposure. After shooting with TTL automatic light

control, the TTL lamp will illuminate in green for approximately 2 seconds.

When automatic light control was not use, the TTL lamp remains red. If the

correct exposure cannot be obtained in TTL shooting mode, switch to

manual shooting mode.

TTL photography

Set the mode switch to [TTL]

Take a photograph

If the full flash has been activated 10 times in a row, allow the

product to rest for 10 minutes before attempting to use it again.

Do not attempt to activate the flash on the unit with the flash

facing downward.

Do not look directly into the flash on the unit.

CAUTION

Requires a SEA&SEA YS converter. Refer to your digital SLR housing

instruction manual for detalis.

CAUTION

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 32 33

Pas de commentaire

Sea & Sea YS-50 Manuel d'instructions Page 24