Sea & Sea YS-50 Manuel d'instructions télécharger pdf (Page 20)

E-19

Connecting the Strobe

Setting and cords used to connect to this model can vary depending on the

camera/housing model.

The various connection methods using different cords are described here.

Refer to “Taking Photographs” on page E-23 for details on taking photographs

while connected using different cords.

When you want to use this strobe with a SLR housing which has a strobe/

converter bulkhead, connect the strobe to the housing with s sync cord (optional).

Some digital SLR housings require a SEA&SEA converter (optional) for TTL

photography. Refer to your digital SLR housing instruction manual for details.

*1 The SEA&SEA YS Converter (optional) is required. For light level control

while a YS Converter is connected, adjust the levels on the YS Converter side.

with

pre-flash(es)

Mode switch

Light level

control dial

Without

pre-flash

Digital camera

Connecting with the Sync Cord

Strobe Setting Guide

Connection cord Fiber-optic cable Sync cord

Camera

Strobe

Manual

11-step

±4-step

11-step 11-step

TTL ー

ーー

TTL

Mode switch

Light level

control dial

Remove the connector cap from the sync cord, and check the

O-ring (strobe/camera or housing)

Check the O-ring to make sure there are no scratches or debris, and apply a

light coating of the included silicon grease.

Remove the strobe’s connector cap

If a sync cord is connected to the unit, the automatic recognition function

will be activated and fiber-optic connection will be disabled even if a fiber

optic cable is connected.

CAUTION

Connector cap

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Sea & Sea YS-50 Manuel d'instructions Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Flashs d'appareils photo Sea & Sea YS-50