Sea & Sea VX-2000 Pro Manuel d'utilisateur télécharger pdf (Page 28)

Gates Underwater Products • 5111 Santa Fe Street, Suite H • San Diego, CA • 92109

858.272.2501 • 800.875.1052 • Fax 858.272.1208 • Reliable@GatesHousings.com • www.GatesHousings.com

Contrast

Brightness

Color

Monitor Adjustment

The EM419 has three adjustments for brightness, color and contrast. These

adjustments can be found on the inside rear half of the housing (see photo).

While the monitor is pre-adjusted at the factory, Gates recommends the monitor be

further adjusted to match the camera being used. This will ensure a consistent match

between the monitor and the image actually being recorded.

Matching the camera and monitor should be done in a darkened area to allow good

viewing of both the monitor and the camera electronic viewfinder (EVF).

With the camera on and the monitor plugged in, compare the image on the EVF to the

monitor. Separate the monitor halves, make a small adjustment to the brightness,

contrast or color control, then mate the halves again and view the results. (It is not

necessary to secure the latches. Simply mating the halves should produce an image.)

Fine tune your adjustments until you are satisfied that the image on the monitor

accurately reflects that being seen in the EVF.

Customer Support

If you have any questions or require further assistance with your EM419 External Color

Monitor, contact your dealer or Gates directly and we’ll be happy to assist.

Phone: 858-272-2501

Fax: 858-272-1208

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 36 37

Pas de commentaire

Sea & Sea VX-2000 Pro Manuel d'utilisateur Page 28